Show Snmp Engineid - Cisco 300 Series Cli Manual

12
Network Management Protocol (SNMP) Commands
User Guidelines
To use SNMPv3, an engine ID must be specified for the device. Any ID can be
specified or the default string, which is generated using the device MAC address,
can be used.
Since the engineID should be unique within an administrative domain, use the
default keyword to configure the Engine ID.
Changing or removing the value of snmpEngineID deletes the SNMPv3 users
database.
The SNMP EngineID cannot be all 0x0 or all 0xF or 0x000000001
Example
The following example enables SNMPv3 on the device and sets the device local
engine ID to the default value.
switchxxxxxx(config)# snmp-server engineid local default
The engine-id must be unique within your administrative domain.
Do you wish to continue? [Y/N]Y
The SNMPv3 database will be erased. Do you wish to continue? [Y/N]Y

12.15 show snmp engineID

Use the show snmp engineID Privileged EXEC mode command to display the local
SNMP engine ID.
Syntax
show snmp engineID
Parameters
N/A
Default Configuration
N/A
Command Mode
Privileged EXEC mode
216 78-21075-01 Command Line Interface Reference Guide