Sntp Client Enable - Cisco 300 Series Cli Manual

7
Clock Commands
Example
The following example enables SNTP Anycast clients.
switchxxxxxx(config)# sntp anycast client enable
7.11

sntp client enable

The sntp client enable Global Configuration mode command enables the SNTP
Broadcast and Anycast client on an interface when the device is in Router mode
(Layer 3). Use the no form of this command to disable the SNTP Broadcast and
Anycast client.
Syntax
interface-id }
sntp client enable {
no sntp client enable { interface-id }
Parameters
interface-id—Specifies an interface ID, which can be one of the following types:
Ethernet port, Port-channel or VLAN.
Default Configuration
The SNTP client is disabled on an interface.
Command Mode
Global Configuration mode - Ethernet port, Port-channel or VLAN.
User Guidelines
This command only works when the device is in Router mode (Layer 3).
The sntp broadcast client enable Global Configuration mode command globally
enables Broadcast clients.
This command enables both.
144 78-21075-01 Command Line Interface Reference Guide