Cisco 300 Series Cli Manual page 596

Small business 300 series managed switches command line interface guide release 1.3

Hide thumbs Also See for 300 Series:

Table of Contents

CDP Commands

cdp globally is disabled

Example 2 - In this example, CDP is globally enabled but disabled on the port and

no information is displayed.

switchxxxxxx#show cdp tlv gi2

cdp globally is enabled

Capability Codes: R - Router,T - Trans Bridge, B - Source Route Bridge

S - Switch, H - Host, I - IGMP, r - Repeater,

P - VoIP Phone,M - Remotely-Managed Device,

C - CAST Phone Port, W - Two-Port MAC Relay

Interface TLV: gi2

CDP is disabled on

Example 3 - In this example, CDP is globally enabled and enabled on the port, but

the port is down and no information is displayed.

switchxxxxxx#show cdp tlv interface gi2

cdp globally is enabled

Capability Codes: R - Router,T - Trans Bridge, B - Source Route Bridge

S - Switch, H - Host, I - IGMP, r - Repeater,

P - VoIP Phone,M - Remotely-Managed Device,

C - CAST Phone Port, W - Two-Port MAC Relay

Interface TLV: gi3

CDP is enabled on

Example 4 - In this example, CDP is globally enabled and enabled on the port,

which is up and information is displayed.

switchxxxxxx#show cdp tlv interface gi1

cdp globally is enabled

78-21075-01 Command Line Interface Reference Guide