Ipv6 Mld Snooping Vlan Mrouter - Cisco 300 Series Cli Manual

IPv6 MLD Snooping Commands
78-21075-01 Command Line Interface Reference Guide
User Guidelines
Multicast router ports can be configured statically with the
forward-all command.
You can execute the command before the VLAN is created.
Example
switchxxxxxx(config)# ipv6 mld snooping vlan 1 mrouter learn pim-dvmrp
39.5

ipv6 mld snooping vlan mrouter

Use the ipv6 mld snooping vlan mrouter Interface Configuration mode command
to define a port that is connected to a Multicast router port. Use the no form of this
command to remove the configuration.
Syntax
vlan vlan-id
ipv6 mld snooping
no ipv6 mld snooping
Parameters
•
vlan-id—Specifies the VLAN.
•
interface-list—Specifies a list of interfaces. The interfaces can be from one
of the following types: port or port-channel.
Default Configuration
No ports defined
Command Mode
Interface Configuration mode
User Guidelines
This command may be used in conjunction with the
command, which is used in older versions to statically configure a port as a
Multicast router.
A port that is defined as a Multicast router port receives all MLD packets (reports
and queries) as well as all Multicast data.
mrouter interface
vlan vlan-id
mrouter interface
bridge multicast
interface-list
interface-list
bridge multicast forward-all
39
657