Mac Address-Table Static - Cisco 300 Series Cli Manual

29
424
Parameters
•
filtering— Filter unregistered Unicast packets.
•
forwarding— Forward unregistered Unicast packets.
Default Configuration
Forwarding.
Command Mode
Interface Configuration mode
Example
The following example drops Unicast packets on VLAN 2 when the destination is
unknown.
switchxxxxxx(config)#
switchxxxxxx(config-if)#

29.18 mac address-table static

Use the mac address-table static Global Configuration mode command to add a
MAC-layer station source address to the MAC address table. Use the no form of
this command to delete the MAC address.
Syntax
mac address-table static
|
[permanent delete-on-reset
no mac address-table static [
Parameters
•
mac-address— MAC address (Range: Valid MAC address)
•
vlan-id— Specify the VLAN
•
interface-id— Specify an interface ID. The interface ID can be one of the
following types: Ethernet port or port-channel (Range: valid ethernet port,
valid port-channel)
2
interface vlan
bridge unicast unknown filtering
mac-address vlan-id
vlan
|
delete-on-timeout
mac-address] vlan vlan-id
78-21075-01 Command Line Interface Reference Guide
Address Table Commands
interface-id
interface
|
secure]