Ip Ssh-Client Server Fingerprint - Cisco 300 Series Cli Manual

SSH Client Commands
78-21075-01 Command Line Interface Reference Guide
no ip ssh-client server authentication
Parameters
None
Default Configuration
SSH server authentication is disabled
Command Mode
Global configuration
User Guidelines
When remote SSH server authentication is disabled, any remote SSH server is
accepted (even if there is no entry for the remote SSH server in the SSH Trusted
Remote Server table).
When remote SSH server authentication is enabled, only trusted SSH servers are
accepted. Use the

ip ssh-client server fingerprint

SSH servers.
Example
The following example enables SSH server authentication:
switchxxxxxx(config)
6.6 ip ssh-client server fingerprint
Use the ip ssh-client server fingerprint command in Global configuration mode to
add a trusted server to the Trusted Remote SSH Server Table. To remove an entry
or all entries from the Trusted Remote SSH Server Table, use the no form of the
command.
Syntax
ip ssh-client server fingerprint {
no ip ssh-client server fingerprint [
Parameters
•
host—DNS name of a SSH server.
# ip ssh-client server authentication
host ip-address
|
host ip-address
|
command to configure trusted
fingerprint
}
]
6
127