Mdix - Cisco 300 Series Cli Manual

23
354
Example
The following example enables Flow Control on port
switchxxxxxx (config)#
(config-if)#
switchxxxxxx

23.10 mdix

Use the mdix Interface Configuration (Ethernet) mode command to enable cable
crossover on a given interface. Use the no form of this command to disable cable
crossover.
Syntax
mdix {on | auto}
no mdix
Parameters
•
on—Enables manual MDIX.
•
auto—Enables automatic MDI/MDIX.
Default Configuration
The default setting is On.
Command Mode
Interface Configuration (Ethernet) mode
Example
The following example enables automatic crossover on port
(config)#
switchxxxxxx
switchxxxxxx(config-if)# mdix auto
interface gi1
flowcontrol on
interface gi5
78-21075-01 Command Line Interface Reference Guide
Ethernet Configuration Commands
1
gi
5.
gi