Show Bridge Multicast Address-Table Static - Cisco 300 Series Cli Manual

Address Table Commands
78-21075-01 Command Line Interface Reference Guide
---- --------------- --------------- ----------
8 ff02::4:4:4
8 ff02::4:4:4

29.29 show bridge multicast address-table static

Use the show bridge multicast address-table static EXEC mode command to
display the statically configured Multicast addresses.
Syntax
show bridge multicast address-table static
mac-multicast-address | ipv4-multicast-address | ipv6-multicast-address] [source
ipv4-source-address | ipv6-source-address] [all | mac | ip
Parameters
•
vlan vlan-id—Specifies the VLAN ID.
•
address—Specifies the Multicast address. The possible values are:
-
mac-multicast-address—Specifies the MAC Multicast address.
-
ipv4-multicast-address—Specifies the IPv4 Multicast address.
-
ipv6-multicast-address—Specifies the IPv6 Multicast address.
•
source—Specifies the source address. The possible values are:
-
ipv4-address—Specifies the source IPv4 address.
-
ipv6-address—Specifies the source IPv6 address.
Default Configuration
When all/mac/ip is not specified, all entries (MAC and IP) will be displayed.
Command Mode
EXEC mode
User Guidelines
A MAC address can be displayed in IP format only if it is within the range
0100.5e00.0000–- 0100.5e7f.ffff.
* gi9
fe80::200:7ff:f gi9
e00:200
[vlan vlan-id] [address
]
29
439