Dot1X Auth-Not-Req - Cisco 300 Series Cli Manual

802. 1 X Commands
78-21075-01 Command Line Interface Reference Guide
switchxxxxxx(config-if)# dot1x host-mode multi-host
switchxxxxxx(config-if)# dot1x host-mode single-host
switchxxxxxx(config-if)# dot1x host-mode multi-sessions

22.17 dot1x auth-not-req

Use the dot1x auth-not-req Interface Configuration (VLAN) mode command to
enable unauthorized devices access to the VLAN. Use the no form of this
command to disable access to the VLAN.
Syntax
dot1x auth-not-req
no dot1x auth-not-req
Parameters
N/A
Default Configuration
Access is enabled.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
An access port cannot be a member in an unauthenticated VLAN.
The native VLAN of a trunk port cannot be an unauthenticated VLAN.
For a general port, the PVID can be an unauthenticated VLAN (although only
tagged packets are accepted in the unauthorized state).
Example
The following example enables unauthorized devices access to VLAN 5.
switchxxxxxx(config)#
switchxxxxxx(config-if)#
interface vlan 5
dot1x auth-not-req
22
337