Lldp Receive - Cisco 300 Series Cli Manual

37
602
Parameters
N/A
Default Configuration
Enabled
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
LLDP manages LAG ports individually. LLDP sends separate advertisements on
each port in a LAG.
LLDP operation on a port is not dependent on the STP state of a port. I.e. LLDP
frames are sent on blocked ports.
If a port is controlled by 802.1x, LLDP operates only if the port is authorized.
Example
switchxxxxxx (config)# interface gi1
switchxxxxxx
(config-if)# lldp transmit
37.3

lldp receive

Use the lldp receive Interface Configuration mode command to enable receiving
LLDP on an interface. Use the no form of this command to stop receiving LLDP on
an interface.
Syntax
lldp receive
no lldp receive
Parameters
N/A
Default Configuration
Enabled
Link Layer Discovery Protocol (LLDP) Commands
78-21075-01 Command Line Interface Reference Guide