Link Aggregation Control Protocol (Lacp) Commands; Lacp System-Priority; Lacp Port-Priority - Cisco 300 Series Cli Manual

Link Aggregation Control Protocol (LACP) Commands

78-21075-01 Command Line Interface Reference Guide
40.1

lacp system-priority

Use the lacp system-priority Global Configuration mode command to set the
system priority. Use the no form of this command to restore the default
configuration.
Syntax
lacp system-priority
no lacp system-priority
Parameters
value—Specifies the system priority value. (Range: 1–65535)
Default Configuration
The default system priority is 1.
Command Mode
Global Configuration mode
Example
The following example sets the system priority to 120.
switchxxxxxx(config)#
40.2

lacp port-priority

Use the lacp port-priority Interface Configuration (Ethernet) mode command to set
the physical port priority. Use the no form of this command to restore the default
configuration.
Syntax
value
lacp port-priority
value
lacp system-priority
40
120
668