Router Resources Commands
78-21075-01 Command Line Interface Reference Guide
51.1
system router resources
Use the system router resources command in Global Configuration mode to
configure the system router resources.
Use the no form of this command to return to the default.
Syntax
system router resources [ip-entries
no system router resources
Parameters
•
ip-entries—The maximum number of IPv4 entries.
Default Configuration
Product specific
Command Mode
Global configuration
User Guidelines
Use the system router resources command to enter new settings for routing
entries. After entering the command, the current routing entries configuration will
be displayed, and the user will be required to confirm saving the new setting to the
startup-configuration and to reboot the system.
Data Validation:
If the new settings exceed the maximum number of routing entries, the command
is rejected and a message is displayed to the user.
If the new settings are lower than the currently in-use routing entries, a
confirmation message is displayed to the user (before the save confirmation
message).
Use the no system router resources command to the default settings.
max-number
]
51
855