Show Voice Vlan - Cisco 300 Series Cli Manual

Voice VLAN Commands
78-21075-01 Command Line Interface Reference Guide
Default Configuration
Disabled
Command Mode
Interface Configuration (Ethernet, Port-channel) mode
User Guidelines
This command is applicable only if the voice VLAN state is globally configured as
OUI voice VLAN (using
The port is added to the voice VLAN if a packet with a source MAC address OUI
address (defined by
VLAN ID does not have to be the voice VLAN, it can be any VLAN.
The port joins the voice VLAN as a tagged port.
If the time since the last MAC address with a source MAC address OUI address
was received on the interface exceeds the timeout limit (configured by
aging-timeout), the interface is removed from the voice VLAN.
Example
The following example enables OUI voice VLAN configuration on gi2.
switchxxxxxx(config)#
switchxxxxxx(config-if)#

33.11 show voice vlan

Use the show voice vlan EXEC mode command to display the voice VLAN status
for all interfaces or for a specific interface if the voice VLAN type is OUI.
Syntax
show voice vlan [type {
Parameters
•
type oui—Common and OUI-voice-VLAN specific parameters are
displayed.
•
type auto—Common and Auto Voice VLAN-specific parameters are
displayed.
voice vlan state).
voice vlan oui-table) is trapped on the port. Note: The packet
interface gi2
voice vlan enable
oui auto interface-id | detailed
| }] [
33
voice vlan
]
537