Show Macro Auto Ports - Cisco 300 Series Cli Manual

Smartport Commands
78-21075-01 Command Line Interface Reference Guide

35.14 show macro auto ports

The show macro auto ports EXEC mode command displays information about all
Smartport ports or a specific one. If a macro was run on the port and it failed, the
type of the port is displayed as Unknown.
Syntax
show macro auto ports [
Parameters
•
interface-id—Interface Identifier (Ethernet interface, port channel)
•
detailed—Displays information for non-present ports in addition to present
ports.
Default Configuration
Display information for all interfaces. If detailed is not used, only present ports are
displayed.
Command Mode
EXEC
Examples
Example 1 - Note that Smartport on switch and phone types was configured
automatically. Smartport on routers was configured statically.
switchxxxxxx# show macro auto ports
Smartport is enabled
Administrative Globally Auto Smartport is enabled
Operational Globally Auto Smartport is enabled
Interface Auto Smartport
Admin State
----------- --------------
gi1 disabled
gi2 enabled
gi3 enabled
gi4 enabled
interface-id | detailed
Persistent Smartport Type
State
----------- ---------------
enabled switch
enabled default
disabled phone
enabled router (static)
]
35
569