23
362
23.19 show interfaces counters
Use the show interfaces counters EXEC mode command to display traffic seen by
all the physical interfaces or by a specific interface.
Syntax
show interfaces counters
Parameters
•
interface-id—Specifies an interface ID. The interface ID can be one of the
following types: Ethernet port or Port-channel.
•
detailed—Displays information for non-present ports in addition to present
ports.
Default Configuration
Display counters for all interfaces. If detailed is not used, only present ports are
displayed.
Command Mode
EXEC mode
Example
The following example displays traffic seen by all the physical interfaces.
switchxxxxxx# show interfaces counters gi1
Port
InUcastPkts
---------- ------------ ------------ ------------ ------------
gi1
0
Port
OutUcastPkts OutMcastPkts OutBcastPkts
---------- ------------ ------------ ------------ ------------
gi1
0
Alignment Errors: 0
FCS Errors: 0
Single Collision Frames: 0
[interface-id | detailed
InMcastPkts
InBcastPkts
0
0
1
35
78-21075-01 Command Line Interface Reference Guide
Ethernet Configuration Commands
]
InOctets
0
OutOctets
7051