Cisco 300 Series Cli Manual page 538

33
538
•
interface-id—Specifies an Ethernet port ID. Relevant only for the OUI type.
•
detailed—Displays information for non-present ports in addition to present
ports. Only valid when type is oui.
Default Configuration
If the type parameter is omitted the current Voice VLAN type is used.
If the interface-id parameter is omitted then information about all interfaces is
displayed.
All ports are displayed. If detailed is not used, only present ports are displayed.
Command Mode
EXEC mode
User Guidelines
Using this command without parameters displays the current voice VLAN type
parameters and local and agreed voice VLAN settings.
Using this command with the type parameter displays the voice VLAN parameters
relevant to the type selected. The the local and agreed voice VLAN settings are
displayed only if this is the current voice VLAN state.
The interface-id parameter is relevant only for the OUI VLAN type.
Examples
The following examples display the output of this command in various
configurations.
Example 1 - Displays the auto voice VLAN parameters (this is independent of the
voice VLAN state actually enabled).
switch>show voice vlan type auto
switchxxxxxx#show voice vlan type auto
Best Local Voice VLAN-ID is 5
Best Local VPT is 5 (default)
Best Local DSCP is 46 (default)
Agreed Voice VLAN is received from switch 00:24:01:30:10:00
Agreed Voice VLAN priority is
Agreed Voice VLAN-ID is 5
0 (active static source)
78-21075-01 Command Line Interface Reference Guide
Voice VLAN Commands