Cisco 300 Series Cli Manual page 856

51
856
The following table displays the conversion between logical entities to HW
entries:
Examples
Example 1
The following example defines the supported number of IPv4 and IPv6 routing
entries. In the example, the configured router entries are less than the router
entries which are currently in use. Using this configurations means that the system
will not have enough resources for the running again in the existing network:
switchxxxxxx#system router resources ip-routes 128 ipv6-routes 32
The maximal number of IPv4 and IPv6 Routing Entries plus non-IP Entries is 2048.
IPv4 Entries
Number of Routes
Number of Neighbors
Number of Interfaces
Non-IP Entries:
93% 400
The new configuration of route entries is less than the route entries which are
currently in use by the system, do you want to continue (note that setting the new
configuration of route entries requires saving the running-configuration file to
startup-configuration file and rebooting the system)? (Y/N) [N] Y
Example 2
The following example defines the supported number of IPv4 routing entries.
switchxxxxxx#system router resources ip-routes 256
The maximal number of IPv4 and IPv6 Routing Entries plus Non-IP Entries is 2048.
In-Use Reserved (Current)
------ ------------------
232 1024
20
12
100
In-Use Reserved (Current)
------ ------------------
78-21075-01 Command Line Interface Reference Guide
Router Resources Commands
Reserved (New)
--------------
128
Reserved (New)
--------------