Show (Mst) - Cisco 300 Series Cli Manual

31
472
Example
The following example sets the configuration revision to 1.
switchxxxxxx(config) #
switchxxxxxx(config-mst) #

31.26 show (MST)

Use the show MST Configuration mode command to display the current or
pending MST region configuration.
Syntax
{current | pending}
show
Parameters
•
current—Displays the current MST region configuration.
•
pending—Displays the pending MST region configuration.
Default Configuration
N/A
Command Mode
MST Configuration mode
Example
The following example displays a pending MST region configuration
switchxxxxxx(config-mst)# show pending
Gathering information ..........
Current MST configuration
Name: Region1
Revision: 1
Instance VLANs Mapped
-------- ------------------------
spanning-tree mst configuration
1
revision
State
-----
78-21075-01 Command Line Interface Reference Guide
Spanning-Tree Commands