Address (Dhcp Host) - Cisco 300 Series Cli Manual

53
876
this mode, the administrator can configure pool parameters, such as the IP subnet
number and default router list.
Example
The following example configures Pool 1 as the DHCP address pool.
Console(config)#
ip dhcp pool network
Console(config-dhcp)#
53 4

address (DHCP Host)

Use the address DHCP Pool Host Configuration mode command to manually bind
an IP address to a DHCP client.
Use the no form of this command to remove the IP address binding to the client.
Syntax
ip-address
address {
hardware-address mac-address}
no address
Parameters
•
address—Specifies the client IP address.
•
mask—Specifies the client network mask.
•
prefix-length—Specifies the number of bits that comprise the address
prefix. The prefix is an alternative way of specifying the client network
mask. The prefix length must be preceded by a forward slash (/).
•
unique-identifier—Specifies the distinct client identification in dotted
hexadecimal notation. Each byte in a hexadecimal character string is two
hexadecimal digits. Bytes are separated by a period or colon. For example,
01b7.0813.8811.66.
•
hardware-address—Specifies the MAC address.
Default Configuration
No address are bound.
Pool1
mask prefix-length {client-identifier unique-identifier |
| }
DHCP Server Commands
78-21075-01 Command Line Interface Reference Guide