Show Lldp Local - Cisco 300 Series Cli Manual

Link Layer Discovery Protocol (LLDP) Commands
78-21075-01 Command Line Interface Reference Guide
Command Mode
EXEC mode
User Guidelines
The command calculates the overloading status of the current LLDP configuration,
and not for the last LLDP packet that was sent.
Example
Switch# show lldp local tlvs-overloading gi1
TLVs Group
------------
Mandatory
LLDP-MED Capabilities
LLDP-MED Location
802.1
Total: 1600 bytes
Left: 100 bytes

37.25 show lldp local

Use the show lldp local Privileged EXEC mode command to display the LLDP
information that is advertised from a specific port.
Syntax
interface-id
show lldp local
Parameters
Interface-id—Specifies a port ID.
Default Configuration
If no port ID is entered, the command displays information for all ports.
Command Mode
Privileged EXEC mode
Bytes Status
------ --------------
31 Transmitted
9 Transmitted
200 Transmitted
1360 Overloading
37
625