Cisco 300 Series Cli Manual page 364

23
364
The following table describes the fields shown in the display.
Field
InOctets
InUcastPkts
InMcastPkts
InBcastPkts
OutOctets
OutUcastPkts
OutMcastPkts
OutBcastPkts
FCS Errors
Single Collision Frames
Multiple Collision
Frames
SQE Test Errors
Deferred Transmissions
Late Collisions
Excessive Collisions
Oversize Packets
Internal MAC Rx Errors
Description
Number of received octets.
Number of received unicast packets.
Number of received multicast packets.
Number of received broadcast packets.
Number of transmitted octets.
Number of transmitted unicast packets.
Nmber of transmitted multicast packets.
Number of transmitted broadcast
packets.
Number of frames received that are an
integral number of octets in length but do
not pass the FCS check.
Number of frames that are involved in a
single collision, and are subsequently
transmitted successfully.
Number of frames that are involved in
more than one collision and are
subsequently transmitted successfully.
Number of times that the SQE TEST
ERROR is received. The SQE TEST
ERROR is set in accordance with the
rules for verification of the SQE detection
mechanism in the PLS Carrier Sense
Function as described in IEEE Std. 802.3,
2000 Edition, section 7.2.4.6.
Number of frames for which the first
transmission attempt is delayed because
the medium is busy.
Number of times that a collision is
detected later than one slotTime into the
transmission of a packet.
Number of frames for which transmission
fails due to excessive collisions.
Number of frames received that exceed
the maximum permitted frame size.
Number of frames for which reception
fails due to an internal MAC sublayer
receive error.
78-21075-01 Command Line Interface Reference Guide
Ethernet Configuration Commands