Interface Ip; Ip Helper-Address - Cisco 300 Series Cli Manual

IP Addressing Commands
78-21075-01 Command Line Interface Reference Guide

43 13 interface ip

Use the interface ip Global Configuration mode command to enter the IP Interface
Configuration mode.
This command can only be used when the device is in Router mode.
Syntax
interface ip -address
Parameters
ip-address—Specifies one of the IP addresses of the device.
Command Mode
Global Configuration mode
User Guidelines
To use this command, you must put the switch into routing mode using
Example
The following example enters the IP interface configuration mode.
switchxxxxxx(config)#
switchxxxxxx(config-ip)#

43 14 ip helper-address

Use the ip helper-address Global Configuration mode command to enable the
forwarding of UDP Broadcast packets received on an interface to a specific
(helper) address. Use the no form of this command to disable the forwarding of
broadcast packets to a specific (helper) address.
This command can only be used when the device is in Router mode.
Syntax
ip-interface | all} address
ip helper-address {
no ip helper-address {
interface ip 192.168.1.1
ip-interface | all} address
udp-port-list
[ ]
43
set system.
719