Exec-Timeout - Cisco 300 Series Cli Manual

15
242
Command Mode
Line Configuration mode
User Guidelines
When this command is enabled, it is activated as follows: connect the console to
the device and press the Enter key twice. The device detects the baud rate
automatically.
Example
The following example enables autobaud.
switchxxxxxx(config)#
switchxxxxxx(config-line)#
15.4

exec-timeout

The exec-timeout Line Configuration mode command sets the session idle time
interval, during which the system waits for user input before automatic logoff. Use
the no form of this command to restore the default configuration.
Syntax
minutes
exec-timeout
no exec-timeout
Parameters
•
minutes—Specifies the number of minutes. (Range: 0-65535)
•
seconds—Specifies the number of seconds. (Range: 0-59)
Default Configuration
The default idle time interval is 10 minutes.
Command Mode
Line Configuration mode
line console
autobaud
seconds
[ ]
78-21075-01 Command Line Interface Reference Guide
Line Commands