Show Snmp Filters - Cisco 300 Series Cli Manual

Network Management Protocol (SNMP) Commands
78-21075-01 Command Line Interface Reference Guide
Default Configuration
No view entry exists.
Command Mode
Global Configuration mode
User Guidelines
This command can be entered multiple times for the same filter. If an object
identifier is included in two or more lines, later lines take precedence.The
command's logical key is the pair (filter-name, oid-tree).
Example
The following example creates a filter that includes all objects in the MIB-II system
group except for sysServices (System 7) and all objects for interface 1 in the
MIB-II interfaces group (this format depends on the parameters define din ifEntry).
switchxxxxxx(config)#
switchxxxxxx(config)#
switchxxxxxx(config)#

12.11 show snmp filters

Use the show snmp filters Privileged EXEC mode command to display the defined
SNMP filters.
Syntax
filtername
show snmp filters [
Parameters
filtername—Specifies the filter name. (Length: 1–30 characters)
Default Configuration
If filtername is not defined, all filters are displayed.
Command Mode
Privileged EXEC mode
f1 system
snmp-server filter
snmp-server filter f2 system.7
f3 ifEntry.*.1
snmp-server filter
]
12
included
excluded
included
211