Qos Wrr-Queue Threshold - Cisco 300 Series Cli Manual

49
824
Parameters
tail-drop— Specifies the tail-drop mechanism.
Default Configuration
The tail-drop mechanism on an egress queue i
s disabled.
Command Mode
Global Configuration mode
User Guidelines
This command can only be used if Advanced mode is enabled.
Example
The following example enables the tail-drop mechanism on an egress queue.
switchxxxxxx(config)#

49.28 qos wrr-queue threshold

Use the qos wrr-queue threshold Global Configuration mode command to assign
queue thresholds globally. Use the no form of this command to restore the default
configuration.
This command is only available in QoS advanced mode.
Syntax
qos wrr-queue threshold gigabitethernet
no qos wrr-queue threshold gigabitethernet
Parameters
•
gigabitethernet—Specifies that the thresholds are to be applied to Gigabit
Ethernet ports.
•
queue-id—Specifies the queue number to which the tail-drop threshold is
assigned.
wrr-queue tail-drop
queue-id threshold-percentage
78-21075-01 Command Line Interface Reference Guide
Quality of Service (QoS) Commands
queue-id