Cisco 300 Series Cli Manual page 409

Address Table Commands
78-21075-01 Command Line Interface Reference Guide
Parameters
•
ip-multicast-address—Specifies the group IP Multicast address.
•
add—Adds ports to the group.
•
remove—Removes ports from the group.
•
interface-list
ethernet
nonconsecutive Ethernet ports with a comma and no spaces. Use a hyphen
to designate a range of ports.
•
port-channel-list
port-channel
nonconsecutive port-channels with a comma and no spaces. Use a hyphen
to designate a range of port channels.
Default Configuration
No Multicast addresses are defined.
Default option is add.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
To register the group in the bridge database without adding or removing ports or
port channels, specify the ip-multicast-address parameter only.
Static Multicast addresses can be defined on static VLANs only.
You can execute the command before the VLAN is created.
Example
The following example registers the specified IP address to the bridge table:
switchxxxxxx(config)#
switchxxxxxx(config-if)#
The following example registers the IP address and adds ports statically.
switchxxxxxx(config)#
—Specifies a list of Ethernet ports. Separate
—Specifies a list of port channels. Separate
interface vlan 8
bridge multicast ip-address
8
interface vlan
29
239.2.2.2
409