Ipv6 Nd Dad Attempts - Cisco 300 Series Cli Manual

44
IPv6 Router Commands
milliseconds bucketsize
Average Packets Per Second = (1000/ ) * .
milliseconds
To disable ICMP rate limiting, set the argument to zero.
Example
The following example shows an interval of 50 milliseconds and a bucket size of
20 tokens being configured for IPv6 ICMP error messages:
ipv6 icmp error-interval 50 20
44.8

ipv6 nd dad attempts

Use the ipv6 nd dad attempts command in Interface Configuration mode to
configure the number of consecutive neighbor solicitation messages that are sent
on an interface while duplicate address detection is performed on the Unicast
IPv6 addresses of the interface.
Use the no form of this command to return the number of messages to the default
value.
Syntax
value
ipv6 nd dad attempts
no ipv6 nd dad attempts
Parameters
value—The number of neighbor solicitation messages. The acceptable range is
from 0 to 600. Configuring a value of 0 disables duplicate address detection
processing on the specified interface; a value of 1 configures a single transmission
without follow-up transmissions.
Default Configuration
1
Command Mode
Interface Configuration
User Guidelines
Duplicate address detection verifies the uniqueness of new Unicast IPv6
addresses before the addresses are assigned to interfaces (the new addresses
732 78-21075-01 Command Line Interface Reference Guide