Lldp Optional-Tlv - Cisco 300 Series Cli Manual

37
Link Layer Discovery Protocol (LLDP) Commands
Syntax
seconds
lldp tx-delay
no lldp tx-delay
Parameters
seconds
tx-delay —Specifies the delay in seconds between successive LLDP
frame transmissions initiated by value/status changes in the LLDP local systems
MIB (range: 1-8192 seconds).
Default Configuration
The default LLDP frame transmission delay is 2 seconds.
Command Mode
Global Configuration mode
User Guidelines
It is recommended that the tx-delay be less than 0.25 of the LLDP timer interval.
Example
The following example sets the LLDP transmission delay to 10 seconds.
switchxxxxxx(config)# 10
lldp tx-delay
37.8

lldp optional-tlv

Use the lldp optional-tlv Interface Configuration (Ethernet) mode command to
specify which optional TLVs are transmitted. Use the no form of this command to
restore the default configuration.
For 802.1, see the lldp optional-tlv 802.1 command.
Syntax
tlv tlv2 tlv5 none
lldp optional-tlv [ ... | ]
606 78-21075-01 Command Line Interface Reference Guide