Honda 2004 Odyssey Service Manual page 1990

Release Motor and Remote Control Switch Test
1. Remove the sliding door panel (see page 20-13).
2. Disconnect the 4P connector from the release
motor and switch.
WHT/RED
BLK
3. Test the release motor by connecting power and
ground according to the table.
Terminal
Direction
OPEN
YEL/RED
Wire side of
female terminals
BLU
C1 C2
4. Check for continuity between the terminals in each
switch position according to the table.
Terminal
Position
HANDLE SWITCH ON
HANDLE SWITCH OFF
5. If the actuator does not operate as specified or the
continuity is not as specified, replace the unit.
C3
C4
22-311