Power Sliding Doors
Closer Motor and Latch Position Switch Test
1. Remove the sliding door panel (see page 20-13).
2. Disconnect the 6P connector from the motor and
switch.
Not used
3. Test the closer motor by connecting power and
ground according to the table.
Terminal
Direction
FORWARD
REVERSE
22-310
Terminal side of
male terminals
B1
B3
4. Check for continuity between the terminals in each
switch position according to the table.
Terminal
B4
Position
FULL LATCH
HALF LATCH
OPEN
HALF LATCH
ON POSITION
(0.29 in (7.3 mm))
5. If the motor does not operate as specified or the
continuity is not as specified, replace the unit.
B5
B6
STRIKER
FULL LATCH
ON POSITION
(0.20 in (5 mm))