Honda 2004 Odyssey Service Manual page 2003

Sliding Door Lock System
Control Unit Input Test
1. Remove the left sliding door panel (see page 20-13).
2. Disconnect the 8P connector (A) from the sliding door control unit (B).
BLU/WHT
3. Inspect the connector and socket terminals to be sure they are all making good contact.
• If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
• If the terminals look OK, go to step 4.
22-324
Not used
WHT/RED
A
B
Not used
YEL/RED
BLK
Not used
Wire side of
female terminals
BLU/RED