Front Turn Signal Light Replacement - Hummer H1 Service Manual

______________________________________________________________________
10-80 Body
GROUND LEAD
LIGHT LEAD
GASKET
MARKER LIGHT
HARNESS LEAD
Figure 10-157: Side Marker Light Assembly
Installation
1. Secure gasket, lamp holder, and ground lead on hood with
four screws, washers, and locknuts (Figure 10-157).
2. Secure lens and cover to lamp holder with two screws.
3. Connect light lead to harness lead.
4. Secure close-off cover to hood with four washers and
screws (Figure 10-156).
5. Ensure side marker light operates properly.

Front Turn Signal Light Replacement

Removal
NOTE: To remove lamp only, perform steps 1 and 2.
1. Remove four screws, lens, and gasket from turn signal
light (Figure 10-158).
2. Remove lamp from socket
3. Remove four screws, washers, and close-off cover from hood.
4. Disconnect two connectors from wiring harness.
5. Remove two nut and lockwasher assemblies, washers,
bracket, and light from hood (Figure 10-159).
6. Remove two screws, lockwashers, and light from bracket.
WIRING
HARNESS
GASKET
LENS
Figure 10-158: Front Turn Signal Assembly
Breakdown
HOOD
LENS
DOOR
CONNECTORS
CLOSE-OFF
COVER
HOOD
LAMP
LIGHT AND
BRACKET
BRACKET
Figure 10-159: Front Turn Signal Bracket
Installation
NOTE: To install lamp only, perform steps 5 and 6.
1. Secure light to bracket with two lockwashers and screws
(Figure 10-159).
2. Secure bracket and light to hood with two washers and nut
and lockwasher assemblies.
3. Connect two connectors to wiring harness (Figure 10-158).
4. Secure close-off cover to hood with four screws and
washers.
5. Install lamp in socket.
6. Secure gasket and lens to light with four screws.
7. Ensure turn signal works properly.
LIGHT
HOOD
®