Hummer H1 Service Manual page 715

______________________________________________________________________
10-88 Body
Adjustments
1. Loosen the torsion assembly mounting bolts enough to
allow the slant door to move side to side (Figure 10-176).
2. Loosen the slant door mounting bolts enough to allow for
an adjustment of the opening clearance at the top of the
door.
3. Position the slant door so that it is centered in the door
frame.
SLANT DOOR HANDLE, LATCH, AND LOCK ACTUATOR
LOCK
ACTUATOR
LOCK ACTUATOR
RETAINING SCREW
Slant Door Handle
Removal
1. Remove the slant door trim (See Section 10).
2. Disconnect the power lock actuator from the slant door
handle assembly (Figure 10-177).
3. Remove the latch actuator cable from the slant door
handle assembly by removing the retaining nut, and bolt.
4. Remove the four retaining nuts, lock washers and flat
washers from the slant door handle assembly.
5. Remove the slant door handle assembly and gasket.
4-1-00
BOLT
DOOR HANDLE
GASKET
Figure 10-177: Slant Door Handle and Latch Replacement
4. Make sure that the top of the slant door has adequate
clearance to the roof shell when opening and closing.
5. Tighten the torsion assembly mounting bolts to 15 lb-ft
(20 N.m).
6. Tighten the slant door mounting bolts to 15 lb-ft (20 N.m).
7. Install previously removed trim.
DOOR HANDLE
ASSEMBLY
FLAT WASHER
LOCK
WASHER
RETAINER
NUT
LATCH
ACTUATOR CABLE
SLANT BACK
LATCH
LATCH BRACKET
MOUNTING BOLT
Installation
1. Install the slant door handle assembly and gasket using the
previously removed
(Figure 10-177).
2. Install the latch actuator cable, retaining bolt, and nut.
3. Connect the power lock actuator to the slant door handle
assembly.
4. Replace the slant door trim.
00-S10-002
door handle hardware
®