Hummer H1 Service Manual page 651

______________________________________________________________________
10-24 Body
Reclining Driver's and Front Passenger's
Seat Replacement
NOTE: Reclining driver's and front passenger's seats are re-
placed similarly. This procedure covers the passenger's seat.
Removal
Remove bolts, washers, and passenger's seat from seat base
(Figure 10-33).
Installation
Secure passenger's seat to seat base with washers and bolts.
Tighten bolts to 15 lb-ft (20 N•m) (Figure 10-33).
SEAT BASE
Figure 10-33: Reclining Front Seat Replacement
Driver's and Front Passenger's Seat Pedestal
Assembly Replacement
NOTE: Seat pedestal assembly replacement for driver's and
front passenger's seats is similar. This procedure covers the
driver's seat pedestal.
Removal
1. Remove seat from seat pedestal.
2. Remove four bolts, lockwashers, and washers securing
seat pedestal to floor.
3. Remove seat pedestal and four spacers from vehicle.
PASSENGER'S SEAT
Installation
1. Install four spacers and seat pedestal in vehicle.
2. Secure seat pedestal to floor with four washers,
lockwashers, and bolts. Tighten bolts to 24 lb-ft (33 N•m).
3. Secure seat to seat pedestal.
Driver's Seat Armrest Replacement
Removal
1. Remove plastic caps covering exposed screws.
2. Remove short screws and lockwashers attaching armrest
to bracket (Figure 10-34).
3. If bracket needs to be replaced, remove long screws
attaching bracket to seat support.
SEAT SUPPORT
BRACKET
Figure 10-34: Driver's Seat Armrest Mounting
Installation
NOTE: If bracket was removed, perform steps 1 through 3.
1. Secure bracket to seat support with one of the long screws.
Do not tighten screw (Figure 10-34).
2. Use large center hole in bracket to locate upper bracket
mounting hole in seat support.
3. Secure top section of bracket to seat support with the other
long screw. Tighten both long screws to 120 lb-in. (14
N•m).
4. Secure the armrest to the bracket with the short screws and
lockwashers. Tighten the short screws to 120 lb-in. (14
N•m).
5. Position the plastic caps over the exposed screw heads.
NOTE: The entire armrest can be positioned vertically or hori-
zontally by pushing the armrest up or down. To adjust the an-
gle of the armrest while it is in the horizontal position, use the
adjusting knob located under the front end of the armrest.
6. Use the adjusting knob to position the armrest as
necessary.
LONG SCREW
ARMREST
SHORT SCREW
®