Hummer H1 Service Manual page 641

______________________________________________________________________
10-14 Body
SPEEDNUT
Figure 10-14: Glovebox Mounting
Installation
1. Assemble console as follows:
a. Insert faceplate, radio, support plate and climate
control panel (as one assembly) into front console and
secure with screw/washers.
b. Remove screw from back of radio and use it to secure
the upper support bracket to the lower support
bracket.
c. Secure upper support bracket to HVAC plenum with
screws.
d. Insert air vents into console and secure with screws.
e. Install glovebox with screws and speednuts.
f. Install ashtray frames and receptacles.
g. Install cup holder.
h. Install CD changer if removed.
i. Install cigarette lighter bezels, shells, heaters and
elements.
j. Secure console harness to console with mounting
clips.
k. Connect console harness leads to cigarette lighter and
12V power supply.
2. Position console close to dashboard.
3. Connect console harness to body electrical harness.
4. Plug antenna and electrical connectors into radio.
5. Fit console carefully into position.
6. Secure console to body brackets with screws.
7. Install right side crashpad.
FRONT CONSOLE
GLOVE BOX
INSTRUMENT PANEL, GAUGES, AND
SWITCHES
Instrument Panel (I.P .) Replacement
Removal
NOTE: Tag all leads prior to removal for installation. If re-
placing instrument panel, refer to procedures in this section to
remove and/or disconnect the various lamps, switches, and
gauges.
1. Disconnect negative battery cables (Section 12).
2. Remove left side crashpad.
3. Remove close-out panel.
4. Remove wiring harness close-out plate.
5. Remove tachometer and clock assembly from I.P. to
access right side I.P. mounting bolt.
6. Remove right side I.P. mounting bolt.
7. Remove two bolts securing I.P. to steering column.
8. Remove two left side I.P. mounting bolts securing I.P. to
A-pillar.
9. Disconnect air hose from side window defrost vent.
10. Remove I.P.
Installation
1. Maneuver I.P. into position between steering wheel and
firewall.
2. Connect air hose side window defrost vent.
3. Loosely install left side I.P. mounting bolts.
4. Loosely install I.P. to steering column mounting bolts.
5. Install right side I.P. mounting bolts
6. Tighten loosely installed bolts from steps 3 and 4.
7. Install tachometer and clock assembly.
8. Install wiring harness close-out plate.
9. Install close-out panel.
10. Install left side dashpad.
11. Connect negative battery cables (Section 12).
®