Guide Cable Replacement - Hummer H1 Service Manual

5-154 Transmission/Transfer Case
SPEED SENSOR AND/OR SWITCH
REPLACEMENT
1. Disconnect harness connector from vehicle speed sensor,
lock indicator switch, and/or range indicator switch
(Figures 5-73 and 5-74).
2. Remove switch and/or sensor from transfer case
(Figures 5-73 and 5-74).
WIRING HARNESS
LOCK INDICATOR
Figure 5-73: Speed Sensor and Lock Indicator
Switch Location
RANGE
INDICATOR
SWITCH
Figure 5-74: Range Indicator Switch Location
3. Install new switch and/or sensor in transfer case.
4. Attach harness connector to switch or sensor.
VEHICLE
SPEED
SENSOR
SWITCH
___________________________________________

GUIDE CABLE REPLACEMENT

1. Remove bolts, nuts, and washers attaching cable bracket to
muffler bracket (Figure 5-75).
2. Remove bolts, nuts, and washers securing guide cable.
3. Remove guide cable and bracket.
4. Attach guide cable bracket to muffler bracket.
5. Attach guide cable bracket to transfer case with washers
and nuts.
6. Install guide cable and brake line support bracket. Tighten
bracket bolt to 27-33 lb-ft (37-45 N•m).
FRONT
PROPELLER
SHAFT
GUIDE CABLE
Figure 5-75: Guide Cable Attachment
GUIDE CABLE
BRACKET
MUFFLER
SUPPORT
BRACKET
BRACKET
TRANSFER
CASE
®