Maplight Replacement - Hummer H1 Service Manual

_____________________________________________________________________
®
Domelight Replacement (Model 90)
Removal
1. Using a screwdriver, snap the dome light assembly from
its base (Figure 10-165)
2. Remove two screws securing domelight base and the
support structure.
3. Slowly pull the light base until the connector for the roof
harness is exposed.
4. Disconnect the roof harness from the dome light base.
5. Remove the dome lamp.
Installation
1. Connect roof harness to dome light base.
2. Install two screws through base and support and attach
base to the roof structure.
3. Install light assembly into base.
4. Verify operation.
Figure 10-165: Domelight Replacement (Model 90)
Rear Seat Courtesy Light Replacement
Removal
1. Carefully pry courtesy light from mounting bracket
(Figure 10-166).
2. Disconnect light from electrical connector.
Installation
1. Connect courtesy light to the electrical connector
(Figure 10-166).
2. Snap courtesy light into mounting bracket.
05745159
ROOF STRUCTURE
SUPPORT
DOME LIGHT
BASE
DOME LIGHT
ASSEMBLY
8-S10-005
S10-212.3
Figure 10-166: Rear Seat Courtesy Light
Replacement

Maplight Replacement

NOTE: The maplight will illuminate when the optional remote
entry feature is activated.
Removal
Remove maplight assembly from bezel (Figure 10-167).
Installation
Install maplight assembly into bezel.
HEADLINER
MAPLIGHT
ASSEMBLY
Figure 10-167: Optional Maplight Replacement
Body 10-83
LOWER
B-PILLAR
TRIM
MOUNTING
BRACKET
COURTESY
LIGHT
FRONT OF
VEHICLE
BULB
BEZEL
RETAINING
BEZEL
CLIPS
4-1-00