Hummer H1 Service Manual page 882

_____________________________________________________
®
5. Immediately turn the ignition key off (3 chirps indicates
exit remote transmitter program mode) and then back on.
The vehicle's horn will sound 2 chirps indicating that the
system is in feature programming mode.
6. Press and release the programming switch on the keyless
entry module 1 time to advance to feature number 1. The
vehicle's horn will chirp 1 time If feature 1 is in the ON
position, Or 2 times if feature 1 is in the OFF position
7. To change the feature, press and release the LOCK button
on the keyless entry remote transmitter, and the
appropriate 1 or 2 chirp signal from the horn will identify
the new selection for that feature (Refer to the table shown
above).
8. To advance to selectable feature number 2, press and
release the programming switch on the keyless entry
module a second time, and again the vehicle's horn will
identify the selection of that feature as "on" or "off". Use
the lock button on the keyless entry remote transmitter to
Feature #
1
2
3
4
5
05745159
Function
Auto door lock
Factory preset ON
Auto drivers door unlock. Fac-
tory preset ON
Auto passenger doors unlock.
Factory preset OFF
*Active or passive theft deter-
rent. Factory preset ACTIVE
*This feature must be set to
passive prior to setting feature
5 to passive
*Active or passive door lock-
ing. Factory preset ACTIVE
*Passive feature requires fea-
ture 4 to be set to passive
Electrical System
change the feature or proceed to the next step if no change
is desired
9. Turn the ignition key off or allow 15 seconds to pass, and
the vehicle's horn will sound 3 chirps indicating
programming mode has been terminated.
Feature Programming Hints
1. Unless otherwise specified, if you wait more than 15 sec-
onds between steps in the programming mode, the system
will automatically terminate the programming mode. This
is indicated by the 3 chirp signal from the vehicle's horn.
Simply start over to complete programming of all features.
2. Test the system to be sure that all selectable features are
functioning according to your customers requests. If you
have missed a feature or changed the wrong feature,
simply re-enter the feature programming mode to make
the appropriate changes.
ON or active, one chip
indication
When active, doors will lock
three seconds after the igni-
tion is turned on. Will not
operate if a door is ajar.
When active, drivers door
will unlock three seconds
after the ignition is turned off
When active, passenger doors
will unlock three seconds
after the ignition is turned off
When active, the theft deter-
rent system arms when the
remote transmitter LOCK
button is pushed
When active, doors will lock
when LOCK button is
pressed, or Auto ignition
LOCK feature is active.
12-109
OFF or passive, two chip
indication
No auto lock
No drivers auto door unlock
No passenger door auto unlock
When the feature is off, or pas-
sive, the theft deterrent system
automatically arms 30 seconds
after the ignition is turned off
and the vehicle is departed. All
doors must be closed.
When this feature is passive,
and feature four is passive, the
doors will lock 30 seconds
after the ignition is turned off
and the vehicle is departed. All
doors must be closed
4-1-00