Hummer H1 Service Manual page 673

______________________________________________________________________
10-46 Body
HOOD
Figure 10-81: Hood Prop Rod Replacement
HOOD
PROP ROD
Figure 10-82: Hood Prop Rod and Bracket
Replacement
Disassembly
1. Remove hood prop rod from eyebolt (Figure 10-83).
2. Remove locknut, washer, bushing, spring, snapring,
bushing, washer, and eyebolt from bracket.
Cleaning and Inspection
NOTE: Clean all components, and examine for wear or dam-
age. Replace if necessary.
Inspect two bushings and spring for cracks, wear, or distortion
(Figure 10-83).
HOOD
PROP ROD
AIRLIFT BRACKET
BRACKET
Assembly
1. Secure bushing to bracket with snapring (Figure 10-83).
NOTE: Length of spring with bracket assembled is 2-1/4 in.
(5.7 cm).
2. Secure washer, eyebolt, spring, bushing, washer, and
locknut to bracket.
3. Install hood prop rod into eyebolt.
SPRING
BUSHING
SNAPRING
Figure 10-83: Hood Prop Rod and Bracket Assembly
Breakdown
Installation
1. Secure hood prop rod and bracket to airlift bracket with
four lockwashers and screws. Tighten screws to 6 lb-ft
(8 N•m) (Figure 10-82).
2. Secure hood prop rod to hood with two washers and cotter
pin (Figure 10-81).
3. Lower hood.
HOOD
PROP ROD
BRACKET
BUSHING
EYEBOLT
®