Running Board Replacement - Hummer H1 Service Manual

____________________________________________________________
®

RUNNING BOARD REPLACEMENT

Removal
1. Remove two clips and pins securing the right and left
curved tubes to the receiver (Figures 13-46 and 13-47).
CLIP
RECEIVER
Figure 13-46:
2. Remove screw, nut, and screw securing the left end cap to
the left curved tube (Figure 13-47).
LEFT END CAP
RUNNING BOARD
ASSEMBLY
RIGHT CURVED
TUBE
Figure 13-47: Left End Cap Secured
to Left Curved Tube
3. Remove screw, nut, and screw securing the right end cap
to the right curved tube.
4. Remove left curved tube from running board.
5. Remove right curved tube from running board.
NOTE: If vehicle has rocker panel protection, remove the ex-
tra clamp plate used on the forward mounting area
between the mounting bracket and receiver.
6. Remove four nuts, washers, and two clamp plates securing
two receivers to
(Figure 13-48).
05745159
PIN
SPRING CLIP
Receiver
LEFT CURVED
TUBE
studs on mounting brackets
REAR MOUNTING AREA SHOWN,
FRONT IS SIMILAR
STUD
Figure 13-48: Receiver and Clamp Plate
NOTE: If vehicle does not have rocker panel protection, per-
form steps 7 and 8. If vehicle is equipped with rocker panel
protection, perform steps 9 and 10.
7. Remove two bolts, lockwashers, and rear mounting
bracket from body (Figure 13-49).
RIGHT SIDE SHOWN,
LEFT SIDE OPPOSITE
REAR
MOUNTING
BRACKET
Figure 13-49: Rear Mounting Bracket
Accessories 13-21
MOUNTING BRACKET
RECEIVER
CLAMP
PLATE
BODY