Rear Bumper Replacement - Hummer H1 Service Manual

9-52 Axles, Suspension, and Frame

REAR BUMPER REPLACEMENT

Removal
1. Remove swing-away spare tire carrier, if equipped (Sec-
tion 6).
2. Remove rear license plate bracket (Section 10).
3. Remove trailer hitch, if equipped (Section 13).
4. Remove two locknuts, washers, bolts, and washers
securing trailer harness to rear bumper (Figure 9-126).
5. Disconnect trailer harness from body harness, and pull
trailer harness through hole in rear bumper.
6. Remove four locknuts, washers, bolts, and washers
securing two tiedown brackets to rear bumper, two
mounting brackets, and outer mounting brackets.
7. Remove eight bolts, washers, and rear bumper from two
mounting brackets.
MOUNTING
BRACKET
OUTER
MOUNTING
BRACKET
BODY HARNESS
REAR BUMPER
TRAILER HARNESS
Figure 9-126: Rear Bumper Replacement
_________________________________________
Installation
1. Install rear bumper on two mounting brackets and secure
with eight washers and bolts. Do not tighten bolts
(Figure 9-126).
2. Install two tiedown brackets on rear bumper, two
mounting brackets, and outer mounting brackets, with four
washers, bolts, washers, and locknuts. Do not tighten
locknuts.
3. Tighten bolts installed in step 1 and locknuts installed in
steps 2, 3, and 4 to 90 lb-ft (122 N•m).
4. Insert trailer harness through hole in rear bumper and
connect trailer harness to body harness.
5. Secure trailer harness to rear bumper with two washers,
bolts, washers, and locknuts.
6. Install trailer hitch, if removed.
7. Install rear license plate bracket.
8. Install swing-away spare tire carrier, if removed.
TIEDOWN BRACKET
REAR BUMPER
®