Hummer H1 Service Manual page 675

______________________________________________________________________
10-48 Body
2. Open hood and loosen center hood stop (Figure 10-85).
3. Gently close hood and loosen lower hinge half locknuts
(Figure 10-86).
Figure 10-86: Lower Hinge Half Locknut Location
4. Gently position hood to obtain proper and even clearance
with A-pillar and both front cowl panels (minimum 3/8" /
maximum 1/2") (Figure 10-85).
5. Tighten lower hinge half locknuts to lock adjustment.
Open hood gently and position guide bracket assembly to
contact center hood stop. Gently close hood to check guide
bracket assembly position (Figures 10-85 and 10-87).
6. Tighten and recheck guide bracket assembly position.
When properly positioned, tighten to 10 lb-ft (14 N•m)
(Figure 10-87).
7. Tighten front lower hinge half locknuts to 28 lb-ft (38
N•m) and recheck hood position (Figure 10-86).
GUIDE BRACKET ASSEMBLY
Figure 10-87: Guide Bracket Assembly Location
8. Lubricate all hood stops, hinges, and guide brackets. Latch
hood (Figure 10-88).
9. Test drive to ensure proper alignment (no squeaks).
10. Check headlight aim and adjust if necessary.
LOWER HINGE
HALF LOCKNUTS
HOOD
CATCH
HOOD
HOOD LATCH
Figure 10-88: Hood Latch and Stop Location
Outer Hood Seal Replacement
Removal
Remove two bolts, seal retainer, and hood seal from body
(Figure 10-89).
Installation
Secure hood seal to body with seal retainer and two bolts
(Figure 10-89).
BODY
Figure 10-89: Outer Hood Seal Replacement
SIDE HOOD
STOP
SEAL RETAINER
HOOD SEAL
®