Hummer H1 Service Manual page 918

_____________________________________________________
®
7. Disconnect green wire connection and remove console.
8. Disconnect 32 pin connector from amplifier and four screws
securing amplifier to mounting bracket (Figure 12-139).
9. Remove amplifier.
10. Disconnect 4 pin connector from overhead console
speaker enclosure.
11. Remove speakers and wiring from overhead console
speaker enclosure.
AMPLIFIER
OVERHEAD
SPEAKER ENCLOSURE
Figure 12-139: Overhead Speaker & Amplifier
Removal.
Installation
1. Install speakers and wiring in overhead console speaker
enclosure and connect 4 pin connector to audio harness.
2. Mount amplifier to mounting bracket with four screws and
connect 32 pin connector to audio harness.
3. Connect dome light wiring and screw overhead console to
roof.
4. Install windshield divider bar cover.
5. Install dome light housing and bulb holder with 3 screws,
and dome light lens.
6. Install upper B-bar cover.
05745159
Electrical System
REAR SEAT AUDIO (RSA) UNIT REPLACEMENT
Removal
1. Remove the cup holders from the auxiliary A/C unit cover
(Figure 12-140).
2. Reach through the cup holder holes in the cover and
release the tension tabs securing the RSA unit to the cover.
3. Pull the RSA unit out enough to expose the harness
connector and disconnect the connector.
CUP
HOLDER
AUXILIARY
UNIT COVER
00-S12-008
Figure 12-140: RSA Unit Replacement.
Installation
1. Connect the harness connector to the RSA unit and insert
into the auxiliary unit cover. Push the RSA unit in until the
tension tabs lock the unit in place.
2. Press the cup holders in place in the auxiliary unit cover.
12-141
TENSION
TAB
4-1-00
RSA
UNIT