Hummer H1 Service Manual page 462

____________________________________________________________
®
RIGHT PARKING BRAKE CABLE REPLACEMENT
Removal
1. Put transmission in PARK, chock wheels, and release
parking brake.
2. Remove cotter pin, washer, clevis pin, and brake clevis
from lever. Discard cotter pin (Figure 7-26).
3. Remove clip securing cable sleeve to caliper cable bracket
and remove parking brake cable assembly from caliper
cable bracket. Discard clip.
4. Slide parking brake cable through parking brake cable
assembly. Remove clip securing cable sleeve to C-beam.
Disconnect parking brake cable from equalizer bar.
Discard clip.
5. Remove two capscrews securing two clamps and parking
brake cable assembly to frame.
6. Remove capscrew, lockwasher, and clamp from bracket.
Discard lockwasher.
NOTE: Perform step 7 if bracket is damaged. If not replacing
bracket, proceed to installation. Note position of cable, bracket,
and clamp prior to removal.
7. Remove two capscrews and bracket from support bracket.
SUPPORT BRACKET
CALIPER CABLE
BRACKET
CLIP
CALIPER
CABLE
LEVER
BRACKET
STOP
BRAKE CLEVIS
CLEVIS PIN
05745159
PARKING BRAKE
CABLE ASSEMBLY
BRACKET
CABLE SLEEVE
PARKING
BRAKE CABLE
Figure 7-26: Right Parking Brake Cable Components
Installation
NOTE: Perform step 1 if clamp bracket was removed, if not,
proceed to step 2.
1. Rotate bracket inward on support bracket and secure with
two capscrews.
2. Install clamp on parking brake cable assembly and install
clamp to bracket with lockwasher and capscrew.
3. Install two clamps on parking brake cable assembly and
install clamps on frame with two capscrews.
4. Install cable sleeve on C-beam and parking brake cable on
equalizer bar and secure with cable clip.
CAUTION: Ensure that the caliper cable bracket is secure
with no signs of looseness and the lever is in contact with the
caliper cable bracket stop. Damage to equipment and poor
performance will result if not aligned properly.
5. Install cable sleeve on caliper cable bracket with brake
cable clip.
6. Install brake clevis on lever with clevis pin, washer, and
cotter pin.
7. Adjust parking brake lever.
PARKING
BRAKE CABLE
CABLE SLEEVE
FRAME
Brake System 7-23
CLIP
EQUALIZER BAR
C-BEAM