Interior And Exterior Lighting - Hummer H1 Service Manual

______________________________________________________________________
10-78 Body

INTERIOR AND EXTERIOR LIGHTING

REPLACEMENT
Service Headlight Assembly Replacement
Removal
NOTE: To remove headlight only, perform steps 1 and 2. To
remove the entire assembly, continue with steps 3 through 6.
1. Loosen three screws and remove retaining ring from head-
light mount (Figure 10-153).
2. Disconnect headlight jumper harness from headlight, and
remove headlight.
3. Loosen two screws securing headlight mount to headlight
housing, and remove mount from housing and spring.
4. Disconnect headlight jumper harness from headlight
housing and remove harness.
5. Disconnect three leads from back of housing.
RETAINING RING
HEADLIGHT HOUSING
HEADLIGHT MOUNT
JUMPER HARNESS
HEADLIGHT
Figure 10-153: Headlight Assembly Replacement
6. Remove three nuts, lockwashers, washers, and housing
from hood.
Installation
NOTE: To install headlight only, perform steps 5 and 6. To in-
stall entire assembly, perform all steps.
1. Connect three leads to back of housing (Figure 10-153).
2. Secure headlight housing to hood with three washers,
lockwashers, and nuts.
3. Secure headlight mount to housing, with spring and two
screws.
4. Connect headlight jumper harness to headlight housing.
5. Connect headlight to jumper harness and secure headlight
to headlight mount with retaining ring with retaining ring.
Tighten three screws.
6. Connect battery ground cable (Section 12).
7. Check headlight for proper operation.
LEADS
SPRING
HOOD
®