Hummer H1 Service Manual page 656

_____________________________________________________________________
®
Figure 10-43: Rear Compartment Wall Location
13. Remove screw/washer assemblies, B-beam trim, and rear
edge trim from B-beam and lower rear compartment wall.
14. Remove domelight.
15. Remove panel fasteners and headliner from roof (Figure 10-44).
Installation
1. Position headliner on roof and install with panel fasteners
(Figure 10-44).
2. Install domelight.
NOTE: Perform steps 3 through 5 for 2-door vehicles without
an enlarged cab.
3. Secure rear edge trim and B-beam trim to B-beam and rear
compartment wall
(Figure 10-43).
B-BAR
CENTER
TRIM
B-PILLAR TRIM
05745159
UPPER REAR
COMPARTMENT WALL
LOWER REAR
COMPARTMENT WALL
with screw/washer assemblies
UPPER
B-BAR
TRIM
Figure 10-45: A-Pillar and B-Bar Interior Trim Components
4. Secure trim to upper rear compartment wall with screw/
washer assemblies.
ROOF
Figure 10-44: Headliner Positioning
5. Install seats.
6. Secure B-pillar trim to B-pillar with washers and screws
(Figure 10-45).
7. Secure upper B-bar trim to roof with screw/washer
assemblies.
8. Secure lower A-pillar trim to A-pillar with screw/washer
assembly.
9. Secure upper A-pillar trim to roof with screw/washer
assemblies (Figure 10-42).
10. Secure center trim to windshield frame and roof with
screw/washer assemblies (Figure 10-45).
11. Secure B-bar center trim to roof with screw/washer
assemblies.
12. Secure grab handle to trim with screws and covers.
ROOF
CENTER TRIM
GRAB HANDLE
COVER
A-PILLAR
LOWER
A-PILLAR
TRIM
B-PILLAR
Body 10-29
HEADLINER