Brushguard Assembly Replacement - Hummer H1 Service Manual

13-10 Accessories

BRUSHGUARD ASSEMBLY REPLACEMENT

NOTE: Brushguard assemblies may be used on vehicles with
or without a winch assembly. The following procedure applies
to vehicles without a winch assembly.
Removal
WARNING: Stand clear of brushguard after removal
of locking pins. Brushguard may swing down, causing
personal injury.
1. Remove two locking pins from support brackets and lower
brushguard.
2. Remove two locknuts, washers, bolts, washers, and
brushguard from support brackets.
3. Remove four locknuts, washers, bolts, washers, and two
support brackets from bumper.
Installation
1. Install two support brackets on bumper with four washers,
bolts, washers, and locknuts. Tighten locknuts to 68 lb-ft
(92 N•m) (Figure 13-27).
2. Position brushguard in brackets and secure with two
washers, bolts, washers, and locknuts.
3. Secure brushguard in upward position with two locking
pins.
_____________________________________________________________
SUPPORT
BUMPER
BRACKET
Figure 13-27: Brushguard Assembly
SWING-AWAY SPARE TIRE CARRIER
REPLACEMENT
Removal
WARNING: Support tire when removing lug nuts. The
spare tire and wheel assembly weighs approximately
150 lbs (68 kg) and personal injury may result if the as-
sembly is not properly supported.
1. Remove lug nuts and wheel/tire assembly from frame
assembly (Figure 13-28).
2. Remove self-tapping screw and washer securing lanyard
to frame and remove lanyard and lock pin.
3. Remove self-tapping screws and guide block from rear
bumper.
4. Remove locknuts, washers, bolts, and stop bracket from
rear bumper.
5. Remove bolts, washers, and hold-down bracket from stop
bracket.
6. Remove bolt, washer, and retaining plate from mounting
bracket.
7. Remove frame assembly from mounting bracket.
8. Remove end caps from frame assembly.
9. Remove locknuts, washers, spacer, bolts, washers, and
mounting bracket from rear bumper.
10. Remove grease fitting from mounting bracket.
BRUSHGUARD
LOCKING
PIN
®