Rearview Mirror Replacement - Hummer H1 Service Manual

______________________________________________________________________
10-36 Body

Rearview Mirror Replacement

Removal
1. Remove screw and rearview mirror from mirror bracket
(Figure 10-59).
NOTE: Perform step 2 only if bracket requires replacement.
Mark location of bracket prior to removal.
2. Remove bracket from windshield.
Cleaning and Inspection
Clean epoxy remains from windshield.
Installation
NOTE: Perform step 1 only if bracket was removed.
1. Secure mirror bracket to windshield with quick-drying
epoxy. Allow to dry (Figure 10-59).
2. Secure rearview mirror to mirror bracket with screw.
WINDSHIELD
MIRROR BRACKET
Figure 10-59: Rearview Mirror
REARVIEW MIRROR
DOOR REPLACEMENT
Door replacement varies in complexity depending on the type
and number of components that must be removed from the old
door and installed on the new door. Removal and installation
of these components are detailed in the previous pages of this
section. Any reference to wiring harness removal and installa-
tion is covered in Section 12. The following door replacement
procedure is written assuming the presence of power equip-
ment.
When replacing doors with manual equipment, follow this pro-
cedure but skip the power/electrical steps. Refer to manual
window regulator removal and installation at the end of this
procedure when needed.
NOTE: Door replacement is basically the same for all doors.
Removal
CAUTION: To avoid damage, support door during removal.
1. Remove sideview mirror (front doors only).
2. Remove door harness from pillar (Section 12).
3. Remove door stop strap assembly.
4. Remove twelve-point bolts and washers securing upper
door hinge to pillar (Figure 10-60).
UPPER
HINGE
PLATE
DOOR
LOWER
HINGE
PLATE
Figure 10-60: Door Mounting
5. Close door.
6. Remove twelve-point bolts and washers securing lower
door hinge to pillar and remove door.
UPPER
DOOR
HINGE
PILLAR
LOWER
DOOR
HINGE
®