Door Seals Replacement - Hummer H1 Service Manual

_____________________________________________________________________
®

DOOR SEALS REPLACEMENT

NOTE: The door seals come in bulk and must be cut to the ap-
propriate lengths. For hard top vehicles, cut 12 feet for the
doors and 10 feet for the body opening. For soft-top vehicles,
cut 6 feet for the doors and 5 feet for the body opening.
Removal
NOTE: Note position of old seals before removal.
1. Remove door strap so that door will swing open far
enough to access seals.
2. Remove the old seal from the door frame and the body
area. Clean any remaining adhesive residue from the door
surface.
Installation
1. Cut the door and body seals to the proper lengths (see note
above).
2. Beginning at the bottom of the door, press door seal
around the outside of the door frame (Figure 10-69).
DOOR STRAP
DOOR SEAL HERE
DOOR
SEAL
DOOR SEAL
CROSS
SECTION
Figure 10-69: Door and Body Seal Replacement
3. Apply body seal in the same location as the seal that was
removed.
4. Install door strap.
05745159
BODY SEAL
TERMINATES
HERE
BODY SEAL
TERMINATES
HERE
ENDS OF
BODY SEAL
CROSS SECTION
BODY SEALS
LOCATION
Figure 10-70: Body Seals Location
DOOR STOP STRAP ASSEMBLY REPLACEMENT
Removal
1. Remove bolt, washer, and door stop strap assembly from
door (Figure 10-71).
2. Remove two bolts, washers, door stop strap assembly, and
courtesy light from A-pillar (front door only).
3. Remove bolt, washer, and door stop strap assembly from
B-pillar (rear door only).
Installation
1. Secure door stop strap assembly to door with washer and
bolt. Tighten bolt 12 lb-ft (16 N•m) (Figure 10-71).
2. Secure courtesy light and door stop strap assembly to A-
pillar with two washers and bolts. Tighten bolts to 12 lb-ft
(16 N•m) (front door only).
3. Secure door stop strap assembly to B-pillar with two
washers and bolts. Tighten bolts to 78 lb-ft (106 N•m)
(rear door only).
DOOR GLASS
Door Glass Replacement
NOTE: Door glass replacement is the same for all doors. This
procedure covers the right front door.
Removal
1. Remove window regulator.
2. Remove beltline seal (Figure 10-72).
NOTE: Mark location of screws prior to removal for installa-
tion.
3. Remove four screws, lockwashers, front and rear chan-
nels, and door window seals from door.
4. Rotate glass/lift channel bracket assembly 90 degrees and
remove through window opening (Figure 10-73).
Body 10-41
BODY SEALS
LOCATION