Center Console Replacement; Front Console Replacement - Hummer H1 Service Manual

_____________________________________________________________________
®

CENTER CONSOLE REPLACEMENT

Removal
1. Remove four screw/washers from center console.
(Figure 10-12).
2. Slide center console back (toward rear seating area) far
enough for rear air vents to clear plenum.
3. Lift console from tunnel.
Installation
1. Carefully lower center console over auxiliary A/C-heat
unit while making sure that rear air vents clear plenum and
line up with cutouts.
2. Slide center console forward so that rear air vents fit into
plenum cutouts.
3. Secure center console to tunnel bracket with four screw/
washers.
CENTER CONSOLE
REAR AIR
VENT
SCREW/
WASHER
Figure 10-12: Center Console Replacement
05745159

FRONT CONSOLE REPLACEMENT

Removal
1.
2.
BRACKET
3.
4.
5.
6.
7.
PLENUM
CUTOUT
NOTE: Faceplate, radio, support plate, and climate control
panel will come out as an assembly.
Remove right side crashpad.
Remove bolts securing front console to body brackets and
screws from top of console (Figure 10-13).
FRONT CONSOLE
Figure 10-13: Front Console Mounting
Pull front console away from dashboard.
Unplug antenna and electrical connectors from radio.
Unplug 56 way console connector from cross body
harness.
Remove front console assembly.
Remove transferable components from console assembly
as follows:
a. Disconnect electrical leads from cigarette lighters and
12V power supply.
b. Remove console harness and mounting clips.
c. Remove cigarette lighter, elements, heaters, shells.
and bezels.
d. Remove ashtray receptacles and frames.
e. Remove cup holder.
f. Remove CD changer if equipped.
g. Remove screws, glovebox, and speednuts (Figure 10-14).
h. Remove screws and air vents.
i. From inside of console, remove the upper rear support
bracket securing the climate control panel and radio to
the HVAC plenum.
j. Reattach lower support bracket to back of radio.
k. Remove screws, faceplate, radio, support plate, and
climate control panel.
Body 10-13